Maybe slightly off topic, but does anyone know anything about any DIY ergo mice projects?
You must log in or # to comment.
A bit late but I found this an interesting project: https://www.youtube.com/watch?v=HTKbrcy7GT0
Ploopy has a few open source options. https://ploopy.co/
This is defintely the direction I am looking for! I didn’t realize qmk supported mouse sensors!
anyone know of a qmk mouse board that’s smaller than ploopy?
No, but if you enjoy having money, I suggest you look into the Om by ErgoDriven.
An actual steal at 20-30 bucks, imo.
Programmable buttons, alterable DpI up to 2400, even got two basically extra buttons, which, counterintuitively, make a ton of sense.
Not the craziest polling rate, but its great for office type work.
